DIN EN 1627 ff – RC1
The airgap which is specified in the SIEGENIA profile
datasheet for the corresponding system must be
It must not be exceeded, nor must it fall below the
The glazing beads should be secured according to
requirements (e.g. by screw connecons, adhesive
bonding, nailing, etc.).
Only mber which meets the following requirements
may be used for an-intruder window elements:
• No knots with a diameter of more than 2 mm
• No cracks
• No other defects
The type of mber used must have at least the
following gross density:
• 0,55 g/cm3 for hardwoods
• 0,45 g/cm3 for sowoods
The annual ring widths must not exceed 4 mm on
In order to create the worst possible condions for the
lever tool, the minimum profile crosssecon used must
be IV 63/78 in accordance with DIN 68 121.
Weather strip bar
RC1 does not place any parcular requirements on the
weather strip bar.
However, the following must be observed with regard
• The distance between screws should be 300 mm
• Corner spacing 50 to 100 mm
The S-RS striker plates must be posioned in such a
way that the locking cams catch in the striker plates as
much as possible.
Secured glazing bead
1 - 18 H45.TITA000S006EN-00