Page 3

awd_b_tung_en

TITAN Intended use Valid for all application diagrams Requirements for use Please note and comply with the following points at all times when using application diagrams and hardware: • The application ranges for the hardware are derived from the size specifications in the assembly instructions/component catalogue and from those in the relevant application diagram. If the values differ, the data in the assembly instructions always applies, with the data in the component catalogue providing an alternative. • If a combination of components with different load-bearing capacities is being used, the application diagram for the component with the lowest load-bearing capacity is always the one that applies. • Guidelines/notes on the product and on liability (VHBH directive as well as the other applicable documents listed here in -directive can be downloaded at www.beschlagindustrie.de/ggsb/richtlinien.asp ). • Specifications from the profile manufacturers/system owners (e.g. for window systems with frames made of timber, PVC, light metal or combinations of materials) or DIN 68121 "Timber profiles for windows and French windows" – with particular regard to potential restrictions for the sash dimensions and sash weight. • Guidelines and, where applicable, application diagrams in the product documentation supplied by the relevant glass or infill panel manufacturer. • In accordance with the application diagrams, the hardware is to be used exclusively for window elements which are installed vertically in walls in permanent structures, unless otherwise indicated. • The application diagrams apply exclusively to hardware used in window elements which open inwards, unless otherwise indicated. • In accordance with the relevant application diagrams, the hardware is to be used exclusively for window elements in which the reduction in glass size (CG) is greater than or equal to the specified value, and the profile weight (PG) is less than or equal to the specified value. • If the application range approved in the application diagrams is exceeded, there is a risk of damage to persons or property. If the application ranges are exceeded, our liability ceases to the extent permissible under law. Reduction in glass size The reduction in glass size (CG) is to be determined for each material (timber, PVC, light metal or combinations of materials) as shown in the following drawings. Profile weight PVC Timber Aluminium The profile weight is the specific weight per running metre of the sash profile (complete sash profile including all reinforcements, glazing beads, etc.). H58.AWD_BG_EN 03.2014 Page 3/11


awd_b_tung_en
To see the actual publication please follow the link above